Whether in daily life or work, you must have seen hexagonal nuts everywhere. The hexagonal nut is mainly used to fasten the fastener of the device with screws. Especially in mechanical equipment, there are many places to fix the parts with hexagonal nuts.
However, due to the frequent disassembly, the inner hexagon of the bolt is easy to grind. At this time, it is difficult to remove it with the inner hexagon wrench. In many cases, it is difficult to remove the nut by damage. This method is troublesome. Needless to say, the loss of nuts and screws is also very large. How to disassemble and wear hexagonal nuts?
For the connection of the inner hexagonal nut head is slightly higher than or is flat with the plane of the fixed part. After cooling, you can use hexagonal nuts with a slightly less than the outer diameter of the inner hexagonal nut. Tighten the nut with the movement handle and remove the inner hexagonal bolt.
The hexagonal nut has many functions, especially the inner hexagonal nut. It is usually the most commonly used fastener for plastic parts. It can be used not only for permanent assembly, but also for fixed parts that are repaired and replaced. Improper selection of hexagonal nuts often leads to assembly, use and quality problems. Design the thread in the mold in advance.
As a widely used fastener, the nuts are small, but it is very effective. Many of them are not easy to disassemble after fixed. Untaned nuts are easy to oxidize and rust, and excessive wear during equipment work. Therefore, it should be checked regularly during use.
How To Disassemble The Wear Hexagonal Nut
May 04, 2023
Leave a message

